Page 1 of 2

Making a "Boy and Girl Flattie"...

Posted: Sun Mar 22, 2015 12:31 pm
by Howard
Good afternoon to all...

Here are the last two "flatties" i have in the works for a while...that is, unless i find a "very interesting subject"...

These two are only about 1 1/4" tall...so there won't be a need for too much "layering" of details...just the usual...

My very best regards...Howard...

Re: Making a "Boy and Girl Flattie"...

Posted: Sun Mar 22, 2015 12:37 pm
by paulrace
Another great start.

Re: Making a "Boy and Girl Flattie"...

Posted: Mon Mar 23, 2015 1:02 pm
by Howard
greetings to all...

these two are ready for primer and finish...i did layer on a few details...see the photo below...also note that a paper clip wire brace has been glued on the back of the boy...his leg is just too fragile and would probably break later...

my very best regards...howard...

Re: Making a "Boy and Girl Flattie"...

Posted: Tue Mar 24, 2015 7:33 am
by les
Clever idea to support those fragile parts!!!

Re: Making a "Boy and Girl Flattie"...

Posted: Tue Mar 24, 2015 4:11 pm
by Howard
good afternoon to all...

the finished "boy and girl flatties " are shown below...

i've now completed all the "flatties" i plan to do for a while...unless i find an interesting subject...

now...back to houses...

my very best regards...howard...

Re: Making a "Boy and Girl Flattie"...

Posted: Tue Mar 24, 2015 6:20 pm
by paulrace
Now we need Antoinette to write you a bio for each one like she's done for hers. :-)

Re: Making a "Boy and Girl Flattie"...

Posted: Wed Mar 25, 2015 8:10 am
by les
Howard, Can we have a picture of all of them together, please???

Re: Making a "Boy and Girl Flattie"...

Posted: Wed Mar 25, 2015 8:22 am
by Howard
les wrote:Howard, Can we have a picture of all of them together, please???
OK...possibly today or tomowwow...Howard...

Re: Making a "Boy and Girl Flattie"...

Posted: Wed Mar 25, 2015 10:47 am
by Howard
Here they are...as of today...Howard...

Re: Making a "Boy and Girl Flattie"...

Posted: Wed Mar 25, 2015 11:05 am
by PutzinVT
Nice, Thanks for sharing..