Here are some close up pictures of the Fireplace Cottage, along with some basic information. I have uploaded a PDF file of the pattern.
The base for this house and all of the other buildings is 2 inches by 2 inches, with a half inch light hole. This house measures 1 ¼ inches wide by 1 ½ inches tall and 5/8 inches deep. This house is just a wee bit deeper than the light hole, so I have marked out the spot where the hole can go, but you can move it up further towards the middle.
I reduce the PWD2s door to fit in the opening, but maybe you have a different door in mind that you would like to use. All four windows are the same size with red cellophane.
I covered this house with a fine cut glass I purchased from 32 Degrees North, but you can find this at just about any craft store. If you haven’t used cut glass before, beware it is glass, so be careful especially if you have little ones that would love to pick it up to play with.
Making a house this small is a lot easier than I thought it would be and lots of fun! Please share your pictures it is always nice to see how everyone adds their own special touch!
Attachments: |
Yellow Cottage2.jpg [ 85.68 KiB | Viewed 13974 times ]
|
Yellow Cottage1.jpg [ 78.74 KiB | Viewed 13974 times ]
|
Cottage house plans.pdf [176.71 KiB]
Downloaded 825 times
|
|